PC Speaker Music is a simple application that will allow you to control the "beep sound" of your PC Speaker.

This list show all posible parameters under the editor, where x/y/z stands for the integer values. Commands D, Q, S ,P and J doesnt use the local delay, they skip as soon as the command has been executed. All parameters (x/y/z) are initialized to zero at the start of each note, so sometimes its not necessary to specify all the parameters.

All numbers are calculated in milliseconds.
· x : Will play the frequency x on the PC Speaker.
· x must be between [19..24000] else an error will occur.
· Dx/y : Sets the global delay to x ms.
· If y is larger than zero, the delay is increased by x.
· Qx/y : Sets the frequenzy screew can be negative.
· All notes will now be played x higher, set x to 0 to reset.
· If y is larger than zero, the screw is increased by x.
· Sx : Will sleep for x ms (Playing last note under sleep).
· Px : Pauses for x ms (Silence under sleep).
· N : N will pause in the current local delay (Dx).
· Fx/y/z : Fades from x to y Hz playing every z note using the delay.
· Tx/y/z : Tremor effect. x: Number of ticks, y: Ontime, z: Offtime.
· Jx/y : Jump to command x, and run loop y times. Remember when this command is processed it has already played the notes once.
· If x is negative, it jumps back x commands.
· > : Begin the playback here.
· < : End the playback here.