RSP Parallel Port Connection OCX 1.2.0

RSP Parallel Port Connection OCX is an ActiveX OCX that helps you connect two PCs using a LapLink parallel cable ( Turbo cable ), the connection dont requires any other software installed in order to work, it can transfer files in any Windows based machine, just plug the cable, start the application and the connection is ready to be used, the control has a very easy to use interface, and very intuitive, the transmission is checked for errors during the transfer, and with full error handling support capable of reporting any possible error that can occur, the transmission occurs in a four bits ( a nibble ) per accepted clock cicle ( limited to the speed of your internal ISA control , normally 1 megahertz ) , this limited is based in the 5 bits transfer limit on a LapLink cable , then one bit is used for sincronization while four is used for transfer of data , the control is in a very early stage of development , several new features will be added to the future releases , future versions may have EPP and ECP support
Its recommended that you set up your parallel ports to either EPP or EPP/ECP mode for use with this cable , but if none of these options are listed the application will work without problem , since it was generated to work with a standard parallel port . The control was set up to use the LPT1 to transfer files
Version restrictions:
- The shareware version has a limit of 500 kb of size to the files to transfer , and the aboutbox appear in the end of execution of the control